JBL SDP-40 Routine Maintenance, Restoring Factory-Defaultsettings, Troubleshooting & Maintenance

Models: SDP-40

1 171
Download 171 pages 54.62 Kb
Page 144
Image 144
ROUTINE MAINTENANCE

Troubleshooting & Maintenance

JBL

ROUTINE MAINTENANCE

The following routine maintenance should be performed on a periodic basis:

Clean the SDP-40 exterior surface with a soft, lint-free cloth. Do not use alcohol, benzene, acetone-based cleaners, or strong commercial cleaners. Do not use a cloth made with steel wool or metal polish. If the SDP-40 is exposed to a dusty environment, a low-pressure blower can be used to remove dust from its exterior surface.

Replace the remote control batteries as needed. The remote control requires two AA batteries. It is recommended to use Alkaline batteries, which last longer without leaking. Refer to page 1-5 for remote control battery installation instructions.

Note:

When the batteries are low on power, the remote control enters a low-voltage condition that prevents it from operating the SDP-40. Normal operation will resume when new batteries are installed.

RESTORING FACTORY-DEFAULT SETTINGS

When factory-default settings are restored, all parameters and user-defined values are restored to their factory-default settings. Before restoring factory-default settings, it is recommended to record user-defined settings.

FACTORY SETTINGS

 

FACTORY SETTINGS

EXIT

 

HAVE BEEN RESTORED

RESTORE DEFAULTS

 

PRESS ANY KEY

 

 

TO RESTART

 

 

 

To restore factory-default settings:

1.Select one of the following options to record user defined settings:

Use the Configuration Tool to download current SDP-40 settings to a personal computer (PC). The configuration tool is available at www.jblsynthesis.com.

Record user-defined settings on the installation worksheet that begins on page A-16.

2.If applicable, press the standby button to activate standby mode.

3.When standby mode is activated, press the standby button to deactivate standby mode.

4.After the standby button is pressed, quickly press and hold the Mute button until the FACTORY SETTINGS menu shown above opens on the on-screen and front panel displays.

6-4

Page 144
Image 144
JBL SDP-40 manual Routine Maintenance, Restoring Factory-Defaultsettings, Troubleshooting & Maintenance