JBL SDP-40 manual On-Screendisplay, Status, Setup, Default, Possible, Parameter, Settings

SDP-40

SETUP

ON-SCREEN DISPLAY

SETUP DISPLAYS ON-SCREEN DISPLAY

Selecting the DISPLAY SETUP menu ON-SCREEN DISPLAY option opens the ON-SCREEN DISPLAY menu shown below, which can be used to customize the on-screen display.

MAIN MENU

MODE ADJUST AUDIO CONTROLS SETUP

SETUP

INPUTS SPEAKERS

REAR PANEL CONFIG DISPLAYS VOLUME CONTROLS TRIGGERS

LOCK OPTIONS

DISPLAY SETUP ON-SCREEN DISPLAY FRONT PANEL DISPLAY

A/V SYNC DELAY	OFF
CUSTOM NAME	OFF
EDIT CUSTOM NAME

ON-SCREEN DISPLAY			ALWAYS ON
STATUS	2 SECONDS		2 SECONDS
			ALWAYS OFF
POSITION		TOP
FORMAT		NTSC
BACKGROUND		ON	TOP
REMOTE STATE		ON	CENTER
			BOTTOM
			SECAM
ON			PAL
OFF			NTSC

			Default	Possible
Parameter			Setting	Settings
STATUS			2 SECONDS	ALWAYS ON, 2 SECONDS,
				ALWAYS OFF
POSITION			TOP	TOP, CENTER, BOTTOM
FORMAT			NTSC	SECAM, PAL, NTSC
BACKGROUND			ON	ON, OFF
REMOTE STATE			ON	ON, OFF
STATUS			ALWAYS ON, 2 SECONDS, ALWAYS OFF
SETUP	DISPLAYS	ON-SCREEN DISPLAY		STATUS

Controls the activation of the on-screen display when the display device is connected to a Main Zone video output connector. When ALWAYS ON is selected, the on-screen display remains activated at

all times. When 2 SECONDS is selected, the on-screen display activates for two seconds whenever a new input source is present or a new command is received. When ALWAYS OFF is selected, the on-screen display remains deactivated at all times, and will not reactivate until the STATUS parameter is reset to ALWAYS ON or 2

SECONDS.

Note:

When the ON-SCREEN DISPLAY menu STATUS parameter is set to ALWAYS OFF, the on-screen display immediately deactivates. Press the OSD button or use the front panel display as a guide to reset the ON-SCREEN DISPLAY menu STATUS parameter to ALWAYS ON or 2 SECONDS.

. . . On-Screen Display continues on page 3-45

3-44