JBL SDP-40 manual Setup, When a custom speaker setup is selected

SETUP

JBL

Setting Crossover Points (continued from page 3-29)

MAIN MENU

MODE ADJUST

AUDIO CONTROLS

SETUP

SETUP

INPUTS

SPEAKERS

REAR PANEL CONFIG DISPLAYS VOLUME CONTROLS TRIGGERS

LOCK OPTIONS

SPEAKER SETUP

CUSTOM SETUP SYNTHESIS 7CH SETUP SPEAKER DISTANCES LEVELS CALIBRATION

		R	SR	RR
		80Hz	80Hz	80Hz
		C
		80Hz
	M	L	SL	RL
	SUB
80Hz		80Hz	80Hz	80Hz

SYNTHESIS 7CH SETUP

!CAUTION!

PRESSING THE V

BUTTON WILL

AUTOMATICALLY CHANGE

THE OUTPUTS TO A

SYNTHESIS

7CH SPEAKER

CONFIGURATION

SYNTHESIS 7CH SETUP

FRONT L/R	80Hz
CENTER	80Hz
SIDE L/R	80Hz
REAR L/R	80Hz
SUB L/R	MONO
SUB XOVER	80Hz
LFE	OFF
ULTRA2 SUB	OFF
BGC	N/A
ASA	APART

ON

OFF

APART

CLOSE

TOGETHER

CUSTOM SETUP

FRONT L/R	80Hz
CENTER	80Hz
SIDE L/R	80Hz
REAR L/R	80Hz
SUB L/R	MONO
SUB XOVER	80Hz
LFE	OFF
ULTRA2 SUB	OFF
BGC	N/A
ASA	APART

LFE ON, OFF

Activates and deactivates the Main Zone audio output connector labeled LFE.

SETUP SPEAKERS SET CROSSOVERS CUSTOM SETUP LFE

When a custom speaker setup is selected:

•Select ON to activate the LFE output connector, configuring the Main Zone audio output connectors for a 7.1-channel speaker setup. The SDP-40 sends LFE information to the LFE output connector.

•Select OFF to deactivate the LFE output connector, configuring the Main Zone audio output connectors for a 5.1-channel speaker setup. The SDP-40 redirects LFE information to the Subwoofer L/R output connectors. If the SUB L/R parameter is set to OFF, the SDP-40 redirects LFE information to the speakers with the lowest crossover point.

SETUP SPEAKERS SET CROSSOVERS SYNTHESIS 7CH SETUP

When a SYNTHESIS 7CH speaker setup is selected, the LFE param- eter cannot be adjusted. The SDP-40 automatically deactivates the LFE output connector and redirects LFE information to the SubwooferL/R output connectors.

3-30