JBL SDP-40 Position, Format, Background, Remote State, Setup, Letter Indicator, Command Bank

SETUP

JBL

On-Screen Display (continued from page 3-44)

POSITION TOP, CENTER, BOTTOM

SETUP DISPLAYS ON-SCREEN DISPLAY POSITION

Controls the vertical alignment of the two-line status on the display device screen. When TOP is selected, the two-line status appears near the top of the display device screen. When CENTER is selected, the two-line status appears centered on the display device screen. When BOTTOM is selected, the two-line status appears near the bottom of the display device screen.

FORMAT SECAM, PAL, NTSC

SETUP DISPLAYS ON-SCREEN DISPLAY FORMAT

Controls the compatibility between the composite and S-video output connectors, the video switcher, and the display device. Select the setting that is compatible with the source components and the display device.

Note:

The FORMAT parameter has no effect on the component video output connector.

BACKGROUND ON, OFF

SETUP DISPLAYS ON-SCREEN DISPLAY BACKGROUND

Determines the on-screen display background. When ON is selected, the on-screen display appears over a solid blue or gray background (depending on the display device). When OFF is selected, the on- screen display appears over the video input signal.

Note:

When the BACKGROUND parameter is set to OFF, the on-screen display automatically deactivates when the display device is connected to the Main Zone component video output connector.

REMOTE STATE ON, OFF

SETUP DISPLAYS ON-SCREEN DISPLAY REMOTE STATE

Activates the remote control command bank indicator, a letter that appears in the top-right corner of the on-screen display to indicate the command bank from which the SDP-40 last received a command. The table below indicates the letter that represents each command bank.

When ON is selected, the command bank indicator appears in the top-right corner of the on-screen display whenever the SDP-40 receives a remote control command. When OFF is selected, the command bank indicator does not appear on the on-screen display when the SDP-40 receives a remote control command.

Letter Indicator	Command Bank
None*	Main Zone
Z	Zone 2
R	Record Zone
S	Shift

*No letter appears when the SDP-40 receives a command from the Main Zone command bank, even if the REMOTE STATE parameter is set to ON.

3-45