JBL SDP-40 manual Main Zone Video Output Connectors, Record Zone Video Output Connectors

Basic Operation

JBL

Rear Panel Overview (continued from page 2-7)

10.Main Zone Video Output Connectors

Provide video output in the Main Zone. Two composite video connectors, two S-video connectors, and one component video connector (BNC) are available. The composite and S-video connectors labeled 1 (OSD) incorporate the on-screen display.

Note:

•Composite video output connectors are available when a composite or S-video source is present.

•S-video output connectors are available when an S-video source is present.

•Component video output connectors are available when a component video source is present.

11.Record Zone Video Output Connectors

Provide video output in the Record Zone. Two composite video connectors and two S-video connectors are available. Alternatively, these connectors can be used to connect a video recording device.

12.RS-232 Connectors

Provide serial control. The RS-232 connector labeled 1 is provided to perform flash memory software upgrades and configuration downloads. The RS-232 connector labeled 2 is provided to support future expansion.

13.Trigger Output Connectors

Provide 12V DC output to control connected components. Three trigger output connectors are available on a removable terminal block. The connector labeled PWR – the power trigger output connector – is not configurable. It is activated when the SDP-40 is activated, and deactivated when the SDP-40 is deactivated. The trigger output connectors labeled 1 and 2 can be configured for remote or program operation.

14.IR IN Connector

Accepts input of IR signals from infrared distribution equipment. One 3.5mm jack that accepts a stereo plug (Tip/Ring connection) or mono plug (Tip/Sleeve connection) is available.

15.Microphone Input Connectors

Provided for future expansion. Four 3.5mm T/R/S or balanced inputs are available.

16.Removable Access Panel

Accommodates connectors for emerging technologies.

2-8