In the State of Massachusetts, the following installation instructions apply:
■Installations and repairs must be performed by a qualified or licensed contractor, plumber, or gasfitter qualified or licensed by the State of Massachusetts.
■If using a ball valve, it shall be a
■A flexible gas connector, when used, must not exceed 3 feet.
IMPORTANT SAFETY INSTRUCTIONS
WARNING: To reduce the risk of fire, electric shock, or injury to persons when using the dryer, follow basic precautions, including the following:
■Read all instructions before using the dryer.
■Do not place items exposed to cooking oils in your dryer. Items contaminated with cooking oils may contribute to a chemical reaction that could cause a load to catch fire.
■Do not dry articles that have been previously cleaned in, washed in, soaked in, or spotted with gasoline, dry- cleaning solvents, or other flammable or explosive substances as they give off vapors that could ignite or explode.
■Do not allow children to play on or in the dryer. Close supervision of children is necessary when the dryer is used near children.
■Before the dryer is removed from service or discarded, remove the door to the drying compartment.
■Do not reach into the dryer if the drum is moving.
■Do not install or store the dryer where it will be exposed to the weather.
■Do not tamper with controls.
■Do not repair or replace any part of the dryer or attempt any servicing unless specifically recommended in this Use and Care Guide or in published
■Do not use fabric softeners or products to eliminate static unless recommended by the manufacturer of the fabric softener or product.
■Do not use heat to dry articles containing foam rubber or similarly textured
■Clean lint screen before or after each load.
■Keep area around the exhaust opening and adjacent surrounding areas free from the accumulation of lint, dust, and dirt.
■The interior of the dryer and exhaust vent should be cleaned periodically by qualified service personnel.
■See installation instructions for grounding requirements.
SAVE THESE INSTRUCTIONS
IMPORTANT: The gas installation must conform with local codes, or in the absence of local codes, with the National Fuel Gas Code, ANSI Z223.1/NFPA 54.
The dryer must be electrically grounded in accordance with local codes, or in the absence of local codes, with the National Electrical Code, ANSI/NFPA 70.
INSTALLATION INSTRUCTIONS
Tools and Parts
Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed here.
Parts supplied
Remove parts package from dryer drum. Check that all parts are included.
■8" or 10" pipe wrench
■8" or 10" adjustable wrench (for gas connections)
■
■Adjustable wrench that opens to 1" (2.54 cm) or
■¹⁄₄" nut driver or socket wrench
■Level
■Vent clamps
■Knife
■
■Caulking gun and compound (for installing new exhaust vent)
■Pliers
■Tape measure
4 Leveling legs
NOTE: Do not use leveling legs if installing the dryer on a pedestal.
Parts needed
Check local codes and with gas supplier. Check existing gas supply, electrical supply and venting. Read “Electrical Requirements,” “Gas Supply Requirements” and “Venting Requirements” before purchasing parts.
4
