OTHERS

 

 

 

 

 

 

 

 

 

 

 

General

 

Signal system

NTSC color

 

 

Power requirements

120 V AC, 60 Hz

 

 

Power consumption

22 W (standby: 0.5 W)

 

Dimensions (width x height x depth)

17.2 × 2.4 × 12.0 inches (435 x 59 x 303 mm)

 

Weight

6.7 lbs. (3.0 kg)

 

 

Operating temperature

41°F (5°C) to 104°F (40°C)

 

Operating humidity

Less than 80 % (no condensation)

 

 

 

 

 

 

 

Terminals

 

 

Video output

1 Vp-p (75)

 

 

 

RCA jack x 1

 

 

 

 

 

 

 

 

Component video output

Y: 1 Vp-p (75)

PB/CB: 700 mVp-p (75)

PR/CR: 700 mVp-p (75)

 

RCA jack x 3

 

 

 

 

 

Rear

HDMI output

 

 

 

HDMI jack x 1

Video: 480p, 720p, 1080i, 1080p, 1080p24 / Audio

 

 

Audio output (Analog)

L/R: 2 Vrms (output impedance: more than 1k)

 

 

RCA jack x 2

 

 

 

 

 

 

 

Audio output (Digital)

500 mVp-p (75)

 

 

 

RCA jack x 1

 

 

 

Optical jack x 1

Digital connector

 

 

Note

• The specifications and design of this product are subject to change without notice.

Maintenance

INTRODUCTION CONNECTIONSPLAYBACKFUNCTION SETUP

Servicing

Please refer to relevant topics on “Troubleshooting” on page 44 before returning the product.

If this unit becomes inoperative, do not try to correct the problem by yourself. There are no user-serviceable parts inside. Turn the unit to the standby mode, unplug the power plug, and please call our toll free customer support line found on the cover of this manual to locate an authorized service center.

Disc handling

Handle the discs so that fingerprints and dust do not adhere to the surfaces of the discs.

Always store the disc in its protective case when it is not used.

Note that discs with special shapes (heart-shaped discs, octagonal discs, etc.) cannot be played back on this unit. Do not attempt to playback such discs, as they may damage the unit.

OTHERS

Cleaning the cabinet

Wipe the front panel and other exterior surfaces of the unit with a soft, slightly damp cloth.

Never use a solvent, thinner, benzene or alcohol to clean the unit. Do not spray insecticide liquid near the unit. Such chemicals may discolor the surface or damage the unit.

Cleaning discs

When a disc becomes dirty, clean it with a cleaning cloth. Wipe the disc from the center to out. Do not wipe in a circular motion.

Do not use solvents such as benzine, thinner, commercially available cleaners, detergent, abrasive cleaning agents or antistatic spray intended for analog records.

Cleaning the disc lens

IR signal check

If the remote control is not working properly, you can use an AM radio or digital camera (including a cellular phone with built-in camera) to see if it is sending out an infrared signal.

• With an AM radio: Tune the AM radio to a nonbroadcasting frequency. Point the remote control towards it, push any button and listen. If the sound from the radio flutters, it is receiving the remote control’s infrared signal.

With a digital camera (including built-in cell phone

cameras):

Point a digital camera towards the

• If this unit still does not perform properly although you

remote control. Push any button on the

refer to the relevant sections and to “Troubleshooting” in

remote control and look through the

this manual, the laser optical pickup unit may be dirty.

digital camera. If the infrared light

Consult your dealer or an authorized service center for

appears through the camera, the remote

inspection and cleaning of the laser optical pickup unit.

control is working.

 

EN

47

Page 49
Image 49
Sears NB530SLX owner manual Maintenance, General, Terminals