Sears Vacuum Cleaner Suction Motorreset, To Removebelt, Tchanging,Brushchanging Andbrushcleaning

SUCTION MOTORRESET

The suction motor reset will shut the motor off if air- flow is sufficiently restricted to cause motor overheat- ing and possible damage to the vacuum cleaner.

Once the reset goes into effect, the vacuum cleaner will not operate for approximately 10 minutes. At this time the unit should be unplugged from the electri- cal outlet and checked for clogging. Follow the instructions under "CLOG REMOVAL" on page 15.

Even though dust bags may appear to be not full, there are times when airflow through them may

become severely restricted. Thiscan happen from picking up fine dust particle materials such as plaster dust, talc or other powders. These materials can clog the pores in the bag and close off airflow, causing the reset button to go into effect. If this condition exists, the bag must be changed. See "BAG CHANG- ING" instructions staffing on page 9.

When all airflow passages are clean, the dust bag

•has been checked to be satisfactory, and approxi- mately 10 minutes have passed, use a pencil, ball point pen tip or similar item to push the reset button back in. See nstruct ons n the Ilustrat on to the right. The reset button must be pushed in for the vacuum cleaner to resume operation.

SUCTIONMOTORRESET

IF SHUT DOWN OCCURS,CHECK FORFULL BAGOR CLOGGEDHOSE. (SEE OPERATOR'SMANUAL)

WAIT APPROXIMATELY10 MINUTES BEFOREATTEMPTINGRESET.

USE BALLPOINTPENFOR RESET.

Set the unit upright, plug the power cord in and restart the unit. If it does not restart, wait an addition-

al five minutes. Try again. If it still does not staff, call Sears for service.

TCHANGING,BRUSHCHANGING ANDBRUSHCLEANING

ElectricalShock Or PersonalInjuryHazard

Disconnectelectrical supply before servicingor cleaning the unit.Failureto do so could resultin electrical shock or personalinjuryfrom cleaner sud- denly starting.

Frequently check and remove hair, string and lint build-up in the brush area. If build-up becomes excessive, follow the steps below. Should the belt become loose or should it break, follow the Belt Removal instructions.

TO REMOVEBELT:

Disconnect electrical supply.The handle must be pulled down and the cleaner turned over.Release the lower plate by pushing the tabs in toward the center,

11