SECO-LARM USA E-941SA-600PQ, E-941SA-1K2PQ Installation Notes, Seco-Larm Electromagnetic Lock

SECO-LARMELECTROMAGNETIC LOCK

Installation Notes:

1.Read this installation manual thoroughly. A clear understanding of the product and this manual will make installation much easier.

2.The electromagnetic lock is designed for indoor use ONLY.

3.The most suitable mounting location for the electromagnetic lock may require the use of additional SECO-LARMaccessories such as Z-brackets, L-brackets, and/or spacer plates. Please see the diagram on page 3 to decide if a particular application requires any mounting accessories. See page 7 for a complete list of SECO-LARMaccessories.

4.Do not run power wires and signal wires in the same conduit as this may cause interference.

5.Do not install a diode in parallel with the electromagnetic lock as this may cause a delay when releasing the door as well as cause residual magnetism.

6.The best location to install the electromagnetic lock is on the inside of the door that is being secured with the wiring concealed in the frame to prevent tampering with the unit.

Installation:

1.Fold the mounting template along the dotted line to form a 90-degree angle.

2.Close the door. Find a mounting location on the door frame near the upper free-moving corner of the door, or as close as possible to the upper corner of the door frame opposite the hinges.

3.Place the template against the door and frame. Mark where the holes are to be drilled.

Door Frame

Ideal

Mounting

Location

4. Drill two holes in the frame and	5. Use a hammer to lightly tap the
three holes in the door as shown	guide pins into the guide pin
on the template.	holes on the armature plate.

Door Frame	Door Frame
	Door
Door
Template

4 SECO-LARM U.S.A., Inc.