SECO-LARM USA E-941SA-600PQ Also Available from SECO-LARM, Voltage Selection Jumpers, EAP-5D1Q

SECO-LARMELECTROMAGNETIC LOCK

10. Once the position of the mounting plate is correct, use the four long self-tapping screws to permanently mount the mounting plate.

Long self-tapping screws

12.Remove the cover from the front of the electromagnet. Run the power leads through the large cable access hole .

Skip this step for E-941SA-300. Power leads are

pre-installed. Faceplate does not detach.

14.Cut the wires so they are long enough to connect with the terminal block. Set the voltage using the selection jumpers based on your input voltage.

Voltage Selection Jumpers

Position two jumpers	Position a jumper over
on all four pins for	the two middle pins for
12VDC operation	24VDC operation

NOTE: Failure to correctly set the input voltage may cause damage to the lock.

NOTE: Connect switching devices like push-to-exit switches between the power source and the positive terminal on the lock. Connecting switching devices to the negative terminal may cause a delay in unlocking.

11.Drill the cable access hole. Run the power leads through the cable access hole in the mounting plate and through the hole in the door frame.

13. Push the electromagnet against the mounting plate so the electromagnet ends are flush with the ends of the mounting plate. Use the Allen wrench to screw the hex-head mounting screws through the bottom of the electromagnet into the mounting bracket.

15.Connect the power wires according to the wiring diagram on page 7. Test the unit. Then replace the front cover and install the hex-head tamper caps.

NOTE: This should be the very last step, as once the tamper caps are in place they are very difficult to remove.

Also Available from SECO-LARM:

Access Control	Stand-Alone	Complete line of	Voltage	Wired or Wireless
Power Supply	Access Keypads	Electromagnetic	Converters or	RTE Plates
		Locks and Strikes	Booster

EAP-5D1Q	SK-1123-SQ	E-941DA-1K2P	ST-LA110-TTQ SD-7202GC-PEQ
	(shown)	(shown)	(shown)	(shown)

6 SECO-LARM U.S.A., Inc.