Seiko Group BP-6000 owner manual Single sheets paper, Left Paper Guide

2. Setting up

❏Single sheets paper

1.Move the paper select lever qtoward the rear of the printer to the SINGLE

SHEET setting.

2. Set the print head adjustment lever w. In general, position 1 is used

for one-part paper. (See page 15)

3. Raise the paper rack to the vertical position and adjust the left

paper guide e to the proper position for the size of the paper being

used.

Note

If the paper is not loaded on the proper mark, the printer may not detect the paper and will issue PAPER ERROR.

4.Place single sheet of paper against the paper rack and let it slide behind the platen.

5.Adjust the right paper guide so that it comfortably holds the paper in between the two paper guides.

Paper Size Marker	Extension Arms
	Right Paper Guide
A3 B4	Paper Select Lever
Left Paper Guide

6.Press the PARK key or the FF key to load the single sheet paper to the top-of-form position 17/72 inch (6mm) below the top edge of the paper. The top-of-form position can be adjusted from 0/72 inch to 180/72 inch (64mm) by using the front panel controls in the setup option.

Note

If the paper is not completely fed in, slightly push the paper downward. If it is still not fed in, look in the TROUBLESHOOTING section.

7.The paper bail automatically lowers to press the paper against the platen when the leading edge of the paper feeds more than one inch onto the platen.

Notes

1.Extension Arms

The extension arms are used to keep large size (Legal, B4) cut sheet paper from falling behind the paper rack. When using the extension arms, pull the arm until it clicks and locks in place.

2.RLF, M.RLF, TEAR OFF, PARK keys are invalid in the cut sheet paper.

14