2-2
Plotting is usually conducted in accordance with the following
procedures.
For information on computer operations, refer to your computer manual.
1Turn on the power for the computer and this device.
For information on turning on the device power, refer to “Turning the
power on/off” (⇒ page 2-3)
2Confirm the status of the device on the control panel.
Confirm that the LEDs are not indicating abnormalities and that the LCD
indicates Data standby status.
Press when the Menu lamp is on.
When the Toner lamp is flashing or off, replace the toner. (⇒ page 2-19)
When the Toner waste bottle lamp is flashing or off, replace the waste
bottle. (⇒ page 2-24)
When the Process lamp is flashing or on, replace the process cartridge.
(⇒ page 2-28)
When the Error lamp is on, refer to chapter 14 for information on
troubleshooting.
3Open your application software on your computer and
create a drawing.
If the device settings do not conform to the application software you are
using, reset the settings for this device (⇒ Chapters 5 to 12).
4Send the data from the computer to this device.