2-47
Chapter 2 Basic operations
(3) Change the apply roll setting
Set the roll used to ON in the apply roll setting process (page 11-6).
It is recommended to set rolls not to be used to OFF.
When using the cut paper of the China series only, this step is not needed.
(4) Place the roll in the drawer
Place the roll of the China series to be used in the drawer. Refer to the
page 2-15 for instructions on replacing the paper roll.
When using the cut paper of the China series only, this step is not needed.
(5) Setting the paper menu
Set the media series of the drawer in which the roll was set to the China
series (page 7-2).
When using the cut paper of the China series only, this step is not needed.
(6) PDL setup
Set the auto media series of the PDL setup for the port to transfer the data
to the China series (page 5-11).
When the China series is operated with the printer driver, set the printer
driver to Chinese (page 5-24).
(7) If not operated as expected
If the China series having been set up does not work as expected, check
the process from steps 1 to 6 again.
Note
◆All of the rolls of the China series cannot be set to OFF at the
same time.
◆If this setting is changed, the device must be restarted.
▼Using paper of Chinese standard series