Using the devices
Using the devices
To establish a transmission link, proceed as follows:
1.Switch the receiver on.
2.Switch a transmitter on.
The transmission link is established and the receiver’s RF level display “RF” reacts.
If you cannot establish a transmission link between transmitter and receiver:
Make sure that transmitter and receiver are set to the same frequency bank and to the same channel.
If necessary, read the chapter “If a problem occurs ...” on page 28.
It is vital to observe the following notes:
Make sure that the desired frequencies are listed in the enclosed frequency information sheet.
Make sure that the desired frequencies are approved and legal in your country and, if necessary, apply for an operating license.
Switching the devices on/off
EM 100 receiver
To switch the receiver on:
00 G3 |
|
|
|
| Briefly press the STANDBY button . |
0MHz |
|
|
|
| |
|
|
|
| The receiver switches on and the “Receiver Parameters” standard display appears. | |
| SET |
|
|
| |
|
|
|
|
| |
|
| To switch the receiver to standby mode: | |||
|
| If necessary, deactivate the lock mode (see page 21). | |||
|
|
| |||
|
|
|
|
| Keep the STANDBY button pressed until “OFF” appears on the display panel. |
|
|
|
|
|
|
|
|
|
|
| When in the operating menu, pressing the STANDBY button will cancel your entry |
|
|
|
|
| (ESC function) and return you to the current standard display. |
|
|
|
|
|
|
17