Preparing the ADN PS power supply for use

Preparing the ADN PS power supply for use

Setting up the power supply

CAUTION

Danger of material damage and personal injury due to stacked power supplies!

When stacking several ADN PS power supplies on top of each other,

the stack may topple over,

the temperature of the individual ADN PS power supplies may drastically increase,

high mechanical loading may be exerted on e.g. the housings, cables or installation surfaces.

This can cause material damage and personal injury.

￿Never stack several ADN PS power supplies on top of each other.

￿Make sure that the air vents are not covered or blocked.

￿ Place the ADN PS power supply on a flat surface as shown.

IFor information on how to mount the power supply into a 19” rack, refer to the detailed instruction manual “ADN Conference System”.

Connecting the ADN PS power supply to the mains power supply

CAUTION

Product damage due to unsuitable mains cables or power outlets!

An unsuitable power supply can damage the product.

￿Use the mains cable (supplied) for connecting the product to the mains power supply.

￿Only use multi-outlet power strips or extension cables with protective ground contacts.

￿Only use mains cables with a 3-pin connector.

￿First connect the mains cable (supplied) to the mains socket C.

￿ Connect the mains cable to the mains power supply. The ADN PS power supply is now ready for operation.

15

100 - 240V 50/60Hz 385W

C

8 ADN PS