Using the receiver

Using the receiver

To establish a transmission link, proceed as follows:

1.Switch the receiver on (see next section).

2.Switch the transmitter on (see the instruction manual of the transmitter). The transmission link is established and the receiver’s RF level display “RF” reacts.

It is vital to observe the notes on frequency selection on page 42.

If you cannot establish a transmission link between transmitter and receiver:

￿Make sure that transmitter and receiver are set to the same frequency bank and to the same channel.

￿Read the chapter “Synchronizing transmitters with receivers” on page 42 and, if necessary, the chapter “If a problem occurs ...” on page 47.

Switching the receiver on/off

40

PEAK0

 

20.12 ew100 G3

10

--30

 

533.875

25

20

 

MHz

 

 

 

-10

 

P

 

RF

 

AF

 

 

 

 

SET



To switch the receiver on:

￿Briefly press the STANDBY button .

The receiver switches on and the “Receiver Parameters” stan- dard display appears.

19