Synchronizing transmitters with receivers

Synchronizing transmitters with receivers – multi-channel operation

In order to ensure an intermodulation-free transmission, use the same frequency bank for all transmission links.

￿Switch off all transmitters of your system that are to be automatically configured.

Channels used by switched-on transmitters are displayed as “used”.

￿With one of the receivers, perform a frequency preset scan to scan the frequency banks for unused channels (“Scan New List”, see page 34). Then “Sync” appears on the display panel of the receiver.

40

PEAK0

Easy Setup

25

-10

B.Ch: 20.

-20

10-30Sync 533.875 MHz

￿Switch one of the transmitters on.

￿Synchronize this transmitter with the receiver via the infra-red inter- face (see page 20).

This establishes a transmission link between the transmitter and the receiver.

￿Repeat for the remaining transmitter and receiver pairs as described above. Leave those transmitters switched on that are already linked to a receiver.

Your multi-channel system is now set up.

Alternatively, you can set the channel on the transmitter manually:

￿Make sure that you set the transmitter to the same frequency bank and the same channel as the receiver.

For information on the setting options of the transmitter, refer to the instruction manual of the transmitter.

You can also freely select the receiving frequencies and store these frequencies in the frequency bank “U”.

If you are using frequencies from the frequency banks “U”, it might be that the receiving frequencies are not intermodulation-free.

To ensure that the desired frequencies are intermodulation-free:

￿Contact your Sennheiser partner (see www.sennheiser.com).

43