Synchronizing transmitters with receivers

Synchronizing transmitters with receivers

When synchronizing a transmitter with a receiver, please observe the following:

￿Only use a transmitter and a receiver from the same frequency range (see the type plate on the transmitter and the receiver).

￿Make sure that the desired frequencies are listed in the enclosed frequency information sheet.

￿Make sure that the desired frequencies are approved and legal in your country and, if necessary, apply for an operating license.

Synchronizing a transmitter with the receiver – individual operation

Upon delivery, transmitter and receiver are synchronized with each other.

If, however, you cannot establish a transmission link between transmitter and receiver, you have to synchronize the channels of the devices.

￿With the receiver, perform a frequency preset scan to scan the frequency banks for unused channels (“Scan New List”, see page 34). Then “Sync” appears on the display panel of the receiver.

40

PEAK0

Easy Setup

 

-10

 

 

 

25

B.Ch: 20.

12

 

-20

 

10

-30

Sync 533.875 MHz

RF

AF

￿Synchronize a transmitter with the receiver via the infra-red interface (see page 20).

This establishes a transmission link between the transmitter and the receiver.

Alternatively, you can set the channel on the transmitter manually:

￿Make sure that you set the transmitter to the same frequency bank and the same channel as the receiver (see the instruction manual of the transmitter).

42