Sennheiser EM 2000, EM 2050 Muting the audio signal, Selecting a standard display

Using the receiver

Muting the audio signal

To mute the audio signal:

￿When one of the standard displays is shown on the display panel, press the STANDBY button.

“RX Mute On?” appears on the display panel.

￿ Press the jog dial.

The audio signal is muted. “RX Mute” flashes in alternation with the current standard display. The display panel is backlit in red.

To unmute the audio signal:

￿Press the STANDBY button.

“RX Mute Off?” appears on the display panel.

￿ Press the jog dial.

The muting is canceled and the display backlighting changes from red to orange again.

If “RX Mute On?” or “RX Mute Off?” appears on the display panel but you do not wish to change the status of the muting function:

￿Press the STANDBY button.

The status of the muting function remains unchanged and the current standard display appears.

Selecting a standard display

￿ Turn the jog dial to select a standard display:

Contents of the display											Selectable standard display
			B.CH: 20.64				**2000**				“Receiver Parameters”
40		PEAK
		0	543.200								appears after switch-on of the receiver and displays the
20		-20							MHz
30		-10
		-30									receiver parameters (see page 7)
10			EQ:				SKM2000
		-40	P	+ 12dB		MUTE
	RF	AF
			543.200 MHz				**2000**				“Transmitter Parameters”*
40		PEAK
		0									(transmitter type/microphone, inverted display)
30		-10	SKM2000 935
20		-20									displays the microphone head (SKM only) and the transmitter
10		-30		Standard
		-40	P – 12dB			MUTE					type
	RF	AF
				PEAK							“Soundcheck” (display with additional function)
		40		0		Soundcheck					displays the signal quality within the transmission area
		30	-10		20.64		**2000**
			-20
		20	-40		543.200					MHz	(see page 21)
		10	-30
		RF		AF	P	MUTE
											“Guitar Tuner”** (display with additional function)
40		PEAK	543.200 MHz				**2000**
		0
30		-10						MUTE			displays the guitar tuner (see page 21)
20		-20
							440 Hz
10		-30
		-40
	RF	AF

*The reading of the transmitter parameters can take up to 2 minutes. If you synchronize your transmitter with the receiver (see page 15), the parameters are read out without delay.

**The “Guitar Tuner” standard display is deactivated upon delivery. To show this standard display, you have to activate it (see page 27).

16