Synchronizing transmitters with receivers

￿Launch the “Wireless Systems Manager” (WSM) software.

￿To scan for unused receiving frequencies and to configure the receivers, proceed as described in the instruction manual of the “Wireless Systems Manager” (WSM) software.

￿Set the corresponding transmitter to the selected frequency bank and to the selected channel either by synchronizing the transmitter with the receiver (see page 15) or by setting the frequency bank and the channel manually (see the instruction manual of the transmitter).

Your multi-channel system is now set up.

Operation without If you want to set up a multi-channel system without using the WSM, proceed as follows: network ￿ Switch off all transmitters of your system that are to be automatically configured.

Channels used by switched-on transmitters are displayed as “used”.

￿With one of the receivers, perform a frequency preset scan to scan the frequency banks for unused channels (“Scan New List”, see page 23).

Then “Sync” appears on the display panel of the receiver.

 

 

 

PEAK

Easy Setup

40

0

30

 

-10

 

 

ew300 G3

20

 

-20

 

 

 

10

 

-30

B.Ch: 20.

24

 

 

-40

Sync 531.375 MHz

 

 

 

RF

 

AF

￿Switch one of the transmitters on.

￿Synchronize a transmitter with the receiver via the infra-red interface (see page 15). This establishes a transmission link between the transmitter and the receiver.

￿Repeat for the remaining transmitter and receiver pairs as described above. Leave those transmitters switched on that are already linked to a receiver.

Your multi-channel system is now set up.

Alternatively, you can set the channel on the transmitter manually:

￿Make sure that you set the transmitter to the same frequency bank and the same channel as the receiver.

For information on the setting options of the transmitter, refer to the instruction manual of the transmitter.

You can also freely select the receiving frequencies and store these frequencies in the frequency banks “U1” to “U6”.

If you are using frequencies from the frequency banks “U1” to “U6”, it might be that the receiving frequencies are not intermodulation-free.

To ensure that the desired frequencies are intermodulation-free:

￿Contact your Sennheiser partner (see www.sennheiser.com).

If you want to use the frequency banks “U1” to “U6”:

￿Set each receiver to the same frequency bank (see page 24).

￿On one of the receivers, select a channel within this frequency bank (see page 24).

￿Assign this channel one of the receiving frequencies (see page 24).

￿Synchronize a transmitter with the receiver (see page 15), OR:

￿Manually set the transmitter to the same frequency bank, channel and frequency that you set on the receiver.

￿Repeat for the remaining transmitters and receivers as described above.

32