Using the bodypack transmitter
Using the bodypack transmitter
To establish a transmission link, proceed as follows:
1.Switch the receiver on (see the instruction manual of the receiver).
2.Switch the bodypack transmitter on (see next section).
The transmission link is established and the display backlighting of the receiver changes from red to orange.
It is vital to observe the notes on frequency selection on page 28.
If you cannot establish a transmission link between transmitter and receiver, read the chapter “Synchronizing the bodypack transmitter with a receiver” on page 28.
Switching the bodypack transmitter on/off
Push the two battery compartment catches and open the battery compartment cover .
| |
|
|
To switch the bodypack transmitter on (online operation):
ON/OFF Briefly press the ON/OFF button .
The bodypack transmitter transmits an RF signal. The “Frequency/Name” standard display appears on the display panel. The red ON LED lights up and the transmission icon is displayed.
To switch the bodypack transmitter on and to deactivate the RF signal on
ON/OFF Keep the ON/OFF button pressed until “RF Mute On?” appears on the display panel.
11