Sennheiser SKM 5200-II If a problem occurs, range, noise, level, level, Problem, channel, channel, section, too low, too high, cannot be, Receiver:, distorted, indication, be changed

If a problem occurs ...

If a problem occurs ...

Problem	Possible cause	Possible solution
No operation	Batteries are flat or	Replace the batteries or
indication	inserted incorrectly,	check if they are inserted
	battery pack is flat	correctly or recharge the
		battery pack
Transmitter	Lock mode is activated	Deactivate the lock mode
cannot be		(see “Deactivating the
switched off/		autolock function
Settings cannot		temporarily” on page 15)
be changed
Receiver:	Transmitter and receiver	Set transmitter and
No RF signal	are not on the same	receiver to the same
	channel	channel
	Transmitter is out of	Check the squelch
	range	threshold setting
		or reduce the distance
		between receiving
		antenna and transmitter
Weak signal	Antenna signal is	Do not clasp the antenna
	attenuated	section
Audio signal has	Transmitter’s input	see “Adjusting the
a high level of	attenuation is adjusted	microphone sensitivity –
background	too high	“ATTEN”” on page 26
noise	Receiver’s output level is	Increase the line output
	adjusted too low	level
Audio signal is	Transmitter’s input	see “Adjusting the
distorted	attenuation is adjusted	microphone sensitivity –
	too low	“ATTEN”” on page 26
	Receiver’s output level is	Reduce the line output
	adjusted too high	level

If a problem occurs that is not listed in the above table or if the problem cannot be solved with the proposed solutions, please contact your local Sennheiser partner for assistance. To find a Sennheiser partner in your country, search at www.sennheiser.com under “Service & Support”.

29