Synchronizing the plug-on transmitter with a receiver

Synchronizing the plug-on transmitter with a receiver

When synchronizing the plug-on transmitter with a receiver, please observe the following:

￿Only use a plug-on transmitter and a receiver from the same frequency range (see the type plates on the transmitter and

the receiver).

￿Make sure that the desired frequencies are listed in the enclosed frequency information sheet.

￿Make sure that the desired frequencies are approved and legal in your country and, if necessary, apply for an operating license.

Synchronizing the plug-on transmitter with the receiver – individual operation

Upon delivery, the plug-on transmitter and the receiver are synchronized with each other. If, however, you cannot establish a transmission link between plug-on transmitter and receiver, you have to synchronize the channels of the devices.

For information on automatic synchronization of the plug-on transmitter with the receiver (individual operation), refer to the instruction manual of the receiver. This information is marked with theicon.

Alternatively, you can set the channel on the plug-on transmitter manually:

￿Make sure that you set the plug-on transmitter to the same frequency bank and the same channel as the receiver (see page 20).

If you still cannot establish a transmission link, refer to the chapter “If a problem occurs ...” on page 29.

26