Servis-Rhino 2160 manual MAIN DRIVELINE & CAT 4 SAFETY SHIELD, Maintenance

MAINTENANCE

MAIN DRIVELINE & CAT 4 SAFETY SHIELD

To remove the main inner driveline shield. Remove the locking screws. Align the bearing tabs with the cone pockets. Mnt-B-0043.Remove the half-guard and remove the bearing ring. Mnt-B-0044.

MAINTENANCE

Inspect the driveline shield for worn areas or cracks. If the shield has any dents or cracks, replace the Shield. While the Shields are off, examine the Driveline for signs of abnormal wear, bent or twisted shafts, or cracks in the shafts or tubes. Check to see that the Drivelines telescoping easily. If the Drivelines do not telescope properly or show signs of abnormal wear, the shaft should be repaired or replaced.

To assemble the main inner driveline shield, grease the yoke groove and inner profile tube. Attach the bearing ring in groove with recesses facing profile tube. Mnt-B-0045.Slide on the half shield. Turn the cone until it engages correctly. Install locking screws. Mnt-B-0046.

2160 06/11 Maintenance Section 5-7

©2011 Alamo Group Inc.