Servis-Rhino 2160 manual General Assembly

ASSEMBLY

ASSEMBLY

General Assembly

To help you assemble your New 2160 and mount it to your tractor, we provide you with drawings, instructions and general information. When needed, you can get information or clarification from Rhino Customer Service.

This publication provides general information not specifically for your case or tractor, but, in connection with the drawings. This publication offers you some valuable assistance - please read it thoroughly.

These instructions have been prepared to assist you in the correct procedure for mounting a 2160 on your tractor.

Throughout these instructions, references are made to right or left directions. Right and left are determined by sitting on the tractor seat and facing the direction of travel.

This is the Safety-Alert symbol. When you see this symbol on your machine or in these instructions, be alert to the potential for personal injury.

Follow recommended precautions and safe operating practices.

A signal word - DANGER, WARNING,	or CAUTION - is used with the Safety Alert
symbol. DANGER identifies the most serious hazards. Decals are red and white.
Safety signs with signal word WARNING	are typically used to point out more serious
hazards. Decals are orange and black.

General precautions are listed on CAUTION safety sign. CAUTION also calls attention to safety messages in these instructions. Decals are yellow and black.

NOTE: This mower unit's hydraulic components have been carefully cleaned and packaged at the factory to prevent contamination from entering the system. However, dust and dirt particles may enter into the sealed components through transportation, handling, rain or just sitting in a dirty or harsh enviroment. Therefore to assure that the hydraulic system is properly clean please adhere to the following procedure.

1.Prepare the area where the unit is to be assembled. The area should be on a hard concrete floor that has been swept clean of all dust and contaminants. Un-package the mower unit carefully so that the seals on the hydraulic components are not broken or pulled off. Lay out parts to make location easy.

2.Inspect and clean all hydraulic hoses and fittings prior to installing them onto the tractor or mower. If dirt or material is seen in any of the parts, they should be washed and cleaned thoroughly with an oil-compatible solution. Do not blow the material further into a hose since this sometimes does not remove the foreign material and can cause damage to hydraulic components down stream.

2160 07/11 Assembly Section 3-2

© 2011 Alamo Group Inc.