INSTALLATION INSTRUCTIONS
2 | (1) Unscrew the 2 screws at the corners of |
the front panel. Keep them as they will |
be used later.
(2)Remove the front panel by pulling the front panel at the lower corners towards you about an inch.
Front panel
Next lift it up and pull it towards you.
CAUTION:
Horizontal
Louver
Front | Exhaust Lever |
panel |
|
Take care not to damage the exhaust lever when removing the front panel.
3 (1)Unscrew the 6 stopper screws of the cabinet. Keep the 4 screws from the top and front , as they will be used later.
(2)Slide the chassis out from the cabinet by pulling on the hand hold located at the bottom center of the chassis.
CAUTION:
Do not remove any material (ex. styrofoam, etc.) from inside the unit.
4 Insert the right closure assembly and the left closure assembly into the top angle and the bottom channels.
Secure the right and left closure to the
cabinet with 6 of the provided screws. (L=13 / 32 ", 10 mm)
5 Open the window sash and place the cabinet on the sill.
Close the window sash securely behind the top angle.
If there is space between the bottom channel and the sill, fill the gap with a thin board or other hard filler.
WARNING
At this step, make sure the cabinet is in- clined approximately 1 cm (3/8”) to the back.
If the cabinet is not properly inclined, the water collected in the bottom tray during operation will not drain properly and may flow into the room where the air conditioner is installed.
Closure assembly
Cabinet
sill | incline backwards about 1cm (3/8") |
|
6
