HOW TO OPERATE
ENERGY SAVER
During normal operation, the thermostat automatically controls cooling and the fan runs continuously. When the ENERGY SAVER is selected, the thermostat automatically controls cooling and the fan automatically stops when the compressor is not operating. (Fan will stop 30 seconds after the compressor stops.Even after the fan stops, the fan will rotate for 2 minutes, every maximum 20 minutes, to detect room temperature.)
| Procedure | Pad | Display / Indicator |
During cooling operation |
| • ENERGY SAVER indicator | |
1 |
|
| |
Touch ENERGY | ENERGY | will light. | |
SAVER pad. | SAVER |
|
2 | To cancel, touch |
| • ENERGY SAVER indicator |
ENERGY SAVER | ENERGY | will go off. | |
| pad again. | SAVER |
|
NOTE: ENERGY SAVER cannot be set during FAN ONLY mode operation.
TO CHANGE AIR FLOW DIRECTION
Adjust the louvers to change the direction of air flow for uniform and efficient cooling of the room.
Horizontal louvers | Vertical louvers |
Adjusts UP/DOWN air flow | Adjusts LEFT/RIGHT air flow |
EXHAUST
If air in your room is stale, set the EXHAUST lever to the OPEN position. This will exhaust stale air to the outside. The EXHAUST lever should normally be kept in the CLOSED position during cooling for maximum efficiency.
EXHAUST Lever
CLOSED OPEN
13