Sharp AL-1661CS ( ) mark.), to read each page, 7Press the [#] key, 3Gently close the RSPF, 5Press the [START] key (), HOW TO USE THE FAX FUNCTION

HOW TO USE THE FAX FUNCTION

When placing the Original on the document glass:

1Confirm that there are no original(s) in the RSPF, and open the RSPF.

2Place the original face down on the document glass. Align the original according to the original scale in the illustration below. (Line up the center of the edge of the original with the

( ) mark.)

Original scale

mark

3Gently close the RSPF.

Note	When using the document glass, do not set
	original(s) in the RSPF.

4If needed, set the original size, resolution, and contrast. Continue with the "DIALING AND TRANSMITTING" section.

5Press the [START] key ().

The set original size appears in the display and then scanning begins.

Note	After the [START] key (	) is pressed, the
	set original size appears in the display.

ORIGINAL SIZE 8.5x11

Make sure that the displayed size is the same as the actual original size. (The factory default setting for the original size is "8.5x11".) If the displayed size is not correct,

press the [CLEAR ALL] key () to stop operation and then change the original size setting. (See "ORIGINAL SIZE" (p.53)) When faxing from the document glass, if the size of the original is different from the specified size, part of the image may be cut off.

6If you have more than one original to read into memory, place the next page, and press the [START] key ()

to read each page.

Go to step 7 after the last page has been scanned.

7Press the [#] key.

Transmission begins.

52