● Since only one copy per original can be made, the number of copies cannot be changed.
● Press the CLEAR key to stop copying in the middle of a run.
While making copies from the SPF, do not place originals of the next copying job. Place them after all copies of the current job have been output.
55
5
Press the START key.
Stream feeding mode
If the stream feeding mode has been enabled using user program No. 4, the SPF indicator will continue to blink for approximately 5 seconds after feeding of all originals is completed. While this indicator is blinking, any new originals placed in the SPF will be fed and copied automatically. See page 35, USER PROGRAMS.
1 Ensure that no original is left on the original table.
2 Adjust the original guides to the size of the originals.
Set the originals face up in the document feeder tray.
3 ● The SPF indicator will light up. If this indicator does not light up, the originals are not properly set or the SPF is not properly closed.
Ensure that the copy paper size in the paper tray is the
4 same size as the originals.
● For best feeding of originals which have binding holes punched into them, insert them so that the holes are positioned to the right or along the side guides.
● Special originals such as transparency film and tracing paper should not be fed through the SPF but should be copied from the original table.
Using the SPF
● Be sure to remove any staples or paper clips from the originals.
● Damaged or crumpled originals may misfeed in the SPF. It is recommended that these originals be copied from the original table.
● Before placing curled or wavy originals into the document feeder tray, be sure to flatten them. If not, original misfeeds may result.
SINGLE PASS FEEDER (AR-SP2)
Single pass feeder (AR
