1
2
3
4
5
6
7
8
9
10
11
12
7-24 WHEN THE GRAPHIC SYMBOLS FLASH ON THE TOUCH PANEL
1Perform steps 1 to 2 of the procedure for “5. ADDING
STAPLES Finisher ”( Page 7-21).
When copies have not been stapled in the staple mode, the following message may be shown on the
display:
Examine stapler
This means that staples have become jammed. Remove them as described below.
Finisher
6. REMOVING JAMMED STAPLES (OPTIONAL)
2Holding the knob, lower part A.
3Remove any jammed staples using your fingertip
or something sharp.
4Holding the knob, return part A to its original
position.
A
A
Stapling area
Caution
Do not touch the stapling area.
The stapler could injure you.