1
2
3
4
5
6
7
8
9
10
11
12
4-9
6Enter the distance values read in step 5 for the
specified area.
- Key in the value for X1 with the digital keys and press the
upper SET key.
- Similarly, set the values for X2, Y1 and Y2.
- When setting X1,X2,Y1 and Y2, the original scale automatically
changes to the next original scale. Set the next original scale
as same procedure.
4Place an original on the glass to specify the area.
- Set the original face up with the bottom toward you, fit its
top left corner against the top left corner of the glass, and
align it with the original scale.
5Using the original scale on the left and the inner
(top) scale, read the position of the desired area as
follows:
- X1 Distance from the top left to the left edge of the specified
area.
- X2 Distance from the top left to the right edge of the specified
area.
- Y1 Distance from the top left to the upper edge of the specified
area.
- Y2 Distance from the top left to the lower edge of the specified
area.
Four rectangular areas can be specified on an original.
7Press the lower SET key.
9Press the START key.
Select other copy modes as required.
8Place the orginal. (Sheet original Page 2-10)
- place the original(s) on the glass with the face down, with
its bottom toward you, with its top left aligned against the
original scale on the left side.
*25.4mm = 1"