Troubleshooting

Picture (Continued)

Problem

 

Possible causes and solutions

 

 

 

Screen freezes and operation

Turn off the power and turn on the power again.

buttons do not work.

If the power is not turned off, perform a reset. (Page 54)

 

Is the disc damaged or dirty? Check the condition of the disc. (Page 9)

 

 

 

There is just audio with no video.

Is the connection cable for video output connected properly? (Pages 14–16)

 

 

 

Widescreen video appears vertically

Is “TV Aspect Ratio” set to match the connected TV? (Page 39)

stretched, or black bands appear at

If you are using a widescreen TV, is the “TV Aspect Ratio” set to “Wide”? (Page 39)

the top and bottom of the screen.

 

 

 

 

 

Square noise (mosaic) appears on

Blocks in images may be visible in scenes with rapid movement due to the

the screen.

 

characteristics of digital image compression technology.

 

 

 

The playback screen will be

This Player complies with analog copy protection. Some discs contain a copy

disturbed if DVD video is recorded

 

prohibiting signal. If you try to play back such discs through a VCR, or record to a

to a VCR, or played back through a

 

VCR and play back the signal, the copy protection will prevent normal playback.

VCR.

 

(Pages 15–16)

 

 

 

Audio is not output, or images are

The audio may not be output or the images may not be played back properly for

not played back properly.

 

some discs in which copyright-protected contents are recorded.

 

 

 

Sound

Problem

 

Possible causes and solutions

 

 

 

No sound, or sound is distorted.

If the volume of the TV or amplifier is set to minimum, turn the volume up.

 

There is no sound during still mode, slow motion playback, fast forward and fast

 

 

reverse. (Pages 32–33)

 

DVD audio recorded in DTS is only output from the DIGITAL AUDIO OUT terminal.

 

 

Connect a DTS compatible digital amplifier or decoder to the DIGITAL AUDIO OUT

 

 

OPTICAL terminal on this Player. (Page 17)

 

Check that the audio cable is connected correctly. (Page 17)

 

Check that the cable plugs are clean.

 

Take out the disc and clean it. (Page 9)

 

Audio may not be output depending on the audio recording status, such as when

 

 

audio other than an audio signal or non-standard audio is recorded for the audio

 

 

content of the disc. (Page 6)

 

 

 

Left and right channels of audio are

Are left and right audio cables connected to the opposite terminal, or is one side

reversed, or sound comes out of

 

disconnected? (Page 17)

only one side.

 

 

 

 

 

Audio is not output, or images are

The audio may not be output or the images may not be played back properly for

not played back properly.

 

some discs in which copyright-protected contents are recorded.

 

 

 

Network

Problem

 

Possible causes and solutions

 

 

 

Cannot connect to the Internet.

Is the LAN cable connected properly?

 

Is the wrong cable such as a modular cable used? Connect a LAN cable to the

 

 

ETHERNET terminal. (Page 18)

 

Is the power for the connected equipment, such as broadband router or modem

 

 

turned on?

 

Is the broadband router and/or modem properly connected?

 

Is the proper value(s) set in the network setting? Check “Communication Setup”.

 

 

(Pages 42–44)

 

 

 

Cannot download BD-LIVE contents.

Is the LAN cable connected properly?

 

Is the USB memory device properly connected? Check that the USB memory

 

 

device is connected to the BD STORAGE/SERVICE terminal of this Player.

 

Check if the BD disc supports BD-LIVE.

 

Check the setting for “BD Internet Access”. (Page 41)

 

 

 

(Continued on the next page)

Appendix

53

Page 55
Image 55
Sharp BD-HP52U operation manual Troubleshooting Picture, Sound, Network