Setting the clock
In this example, the clock is set for the
1 Press the
2 Press the CLOCK button and within 5 seconds, press the MEMO- RY/SET button.
3 Press the TUNING/TIME (
or 
) button to select
"0:00" | The |
| (0:00 - 23:59) |
"AM 12:00" | The |
| (AM 12:00 - PM 11:59) |
"AM 0:00" | The |
| (AM 0:00 - PM 11:59) |
Note that this can only be set when the unit is first installed or it has been reset. [Refer to "Clearing all the memory (reset)" on page 29 for details.]
4 Press the TUNING/TIME (
or 
) button to adjust the hour and then press the MEMORY/SET button.
Press the TUNING/TIME (
or 
) button once to advance the time by 1 hour.
Hold it down to advance continuously.
When the
5 Press the TUNING/TIME (
or 
) button to adjust the minutes and then press the MEMORY/SET button.
Press the TUNING/TIME (
or 
) button once to advance the time by 1 minute. Hold it down to change the time in
The hour will not advance even if minutes advance from "59" to "00".
The clock begins counting from "0" seconds. (Seconds are not displayed.) The time display will disappear after a few seconds.
To confirm the time display:
Press the CLOCK button.
The time display will appear for about 5 seconds.
Note:
The "CLOCK" or time will flash at the push of the CLOCK button when the AC power supply is restored after a power failure or unplugging the unit.
Readjust the clock as follows.
To readjust the clock:
Perform "Setting the clock" from step 1. If the time display is flashing, step 3 (for selecting the
To change the
1Clear all the programmed contents. [Refer to "Clearing all the memory (reset)" on page 29 for details.]
2Perform "Setting the Clock" from step 1.
Basic Operation - Setting the clock -
15
02/1/10
