•Headphones
•Before plugging h_or unplugging the headphones, reduce the vol- ume.
•Be sure your headphones have a 1/8" (3.5 mm) diameter plug and are between I6 ohms and 50 ohms impedance. The recom- mended impedance is 32 ohms.
•Plugging in the headphones disconnects the speakers automati- cally. Adjust the volume using the VOLUME control.
Troubleshooting chart
Many potential problems can be resolved by the owner without call- ing a service technician.
If something is wrong with this product, check the following before calling your authorized SHARP dealer or service center.
•General
| Symptom |
| Possible | cause |
|
• | The clock is not set to the | • | Did a power failure occur? | Reset | |
| correct time. |
| the clock. (Refer | to page | I5.) |
• | When a button is pressed, | • | Set the unit to the power stand- | ||
| the unit does not respond, |
| by mode and then turn it back on. | ||
|
| • | If the unit still malfunctions, reset | ||
|
|
| it. (Refer to page 33.) |
| |
• | No sound is heard. | • | Is the volume level set to "0"? | ||
|
| • Are the headphones connected? | |||
|
| • | Are the speaker | wires discon- | |
|
|
| nected? |
|
|
•CD player
Symptom | Possible cause |
• Playback does not start. • Is the disc loaded upside down?
•Playback stops in the mid- • Does the disc satisfy the stan-
die or is not performed |
| dards? |
|
properly. | • | Is the disc | distorted or |
|
| scratched? |
|
• Ptayback sounds are | • | Istheunitlocatednearexcessive | |
skipped, or stopped in the |
| vibrations? |
|
middle of a track. | • | Is the disc | very dirty? |
• Has condensation formed inside the unit?
32