Sharp CD-SW300 System connections (continued), Preparation for Use

CD-SW300

System connections (continued)

Antenna connection

Supplied FM antenna:

Connect the FM antenna wire to the FM 75 OHMS jack and position the FM antenna wire in the direction where the strongest signal can be received.

Supplied AM loop antenna:

Connect the AM loop antenna to the AM and GND terminals. Position the AM loop antenna for optimum reception. Place the AM loop antenna on a shelf, etc., or attach it to a stand or a wall with screws (not supplied).

FM		AM loop
antenna		antenna
	Black	White
	ANTENNA
FM		GND AM

2.Connect the subwoofer light-up wire to the SUBWOOFER LIGHT-UP jack.

SUBWOOFER

Speaker Light-Up connection

Connect the speaker light-up wires to the SPEAKERS LIGHT-UP jacks for speaker illumination. To turn off the speaker light-up feature, press the CLEAR/DIMMER button on the remote control for

Preparation for Use

12

75 OHMS

Note:

Placing the antenna on the unit or near the AC power cord may cause noise pickup. Place the antenna away from the unit for better reception.

Installing the AM loop antenna:

< Assembling >	< Attaching to the wall >
	Wall Screws (not supplied)

Speaker connection

FRONT SPEAKERS:

Connect the black wire to the FRONT SPEAKERS minus (-) termi- nal, and the red wire to the FRONT SPEAKERS plus (+) terminal.

SUBWOOFER:

1.Connect the black wire to the SUBWOOFER minus (-) terminal, and the red wire with purple insulation tube to the SUBWOOFER plus (+) terminal.

Purple	Red
	Black

2 seconds or more.

LEFT SPEAKER RIGHT SPEAKER

SPEAKERS LIGHT-UP RIGHT LEFT

Note:

Placing the right speaker light-up wire to the RIGHT jack and the left speaker light-up wire to the LEFT jack.

Caution:

Never mistake the FRONT SPEAKERS and the SUBWOOFER terminals. The unit or the speakers may be damaged.

If you use other speakers with an impedance lower than that specified, the unit may be damaged. Front speakers: 6 ohms,

Subwoofer: 12 ohms.
Do not mistake the right and the left
channels. The right speaker is the one on
the right side when you face the unit.
Do not let the bare speaker wires touch
each other.
Do not stand or sit on the speakers. You may
be injured.	Incorrect
Do not allow any objects to fall into or to be
placed in the bass reflex duct.