Headphones
Before plugging in or unplugging the headphones, reduce the vol- ume.
Be sure your headphones have a 1/8" (3.5 mm) diameter plug and impedance between 16 and 50 ohms. The recommended impedance is 32 ohms.
Plugging in the headphones disconnects the speakers automati- cally. Adjust the volume using the VOLUME control.
Troubleshooting chart |
Many potential problems can be resolved by the owner without calling a service technician.
If something is wrong with this product, check the following before calling your authorized SHARP dealer or service center.
General |
|
| |
|
|
| |
Symptom | Possible cause |
| |
|
|
| |
The clock is not set to the | Did a power failure occur? Reset |
| |
correct time. | the clock. (Refer to page 16.) |
| |
|
|
| |
When a button is pressed, | Set the unit to the power stand- |
| |
the unit does not respond. | by mode and then turn it back on. |
| |
| If the unit still malfunctions, reset |
| |
| it. (Refer to page 41.) |
| |
|
| References | |
No sound is heard. | Is the volume level set to "0"? | ||
| |||
| Are the headphones connected? |
| |
| Are the speaker wires discon- |
| |
| nected? |
| |
|
|
| |
CD player |
|
| |
|
|
| |
Symptom | Possible cause |
| |
|
|
| |
Playback does not start. | Is the disc loaded upside down? |
| |
Playback stops in the mid- | Does the disc satisfy the stan- |
| |
dle or is not performed | dards? |
| |
properly. | Is the disc distorted or |
| |
|
| ||
| scratched? |
| |
|
|
| |
Playback sounds are | Is the unit located near excessive |
| |
skipped, or stopped in the | vibrations? |
| |
middle of a track. | Is the disc very dirty? |
| |
|
| ||
| Has condensation formed inside |
| |
| the unit? |
| |
|
|
|
39