Connecting to a Computer

Connecting to a Computer Using the DVI to 15-pin D-sub Adaptor and the RGB Cable (INPUT 2)

1 Connect a DVI to 15-pin D-sub adaptor to the projector.

2 Connect the above adaptor to an RGB cable.

3 Connect the above cable to the computer.

•Secure the connectors by tightening the thumbscrews.

Note

•Refer to “Computer Compatibility Chart” on page 66 for a list of computer signals compatible with the projector. Use with computer signals other than those listed may cause some of the functions not to work.

•When connecting the projector to a com-

puter in this way, select “RGB” for “Signal

Type” on the OSD menu or press on the remote control. (See page 52.)

•A Macintosh adaptor may be required for use with some Macintosh computers. Contact your nearest Sharp Authorized Service Center or Dealer.

•Depending on the computer you are us- ing, an image may not be projected unless the signal output setting of the computer is switched to the external output. Refer to the computer operation manual for switch- ing the computer signal output settings.

Optional

accessory

DVI to 15-pin D-sub adaptor

Type: AN-A1DV (7.9" (20 cm))

To INPUT 2 terminal

DVI to 15-pin D-sub adaptor (sold separately)

RGB cable (commercially available)

To RGB output terminal

Notebook computer

and Connections Setup

Connecting the thumbscrew cables

■ Connect the thumbscrew cable making sure that it fits cor-

 

rectly into the terminal. Then, firmly secure the connec-

 

tors by tightening the screws on both sides of the plug.

 

■ Do not remove the ferrite core attached to the RGB cable.

Ferrite core

-21