Sharp G14000 Recording from the radio, Dubbing from tape to tape, Erasing recorded tapes

To perform programmed recording:

1Program discs and tracks. (See page 25.)

2Press the button.

3Press the / button.

To stop recording:

Press the button.

The disc and tape will stop.

Recording from the radio

1Tune in to the desired station. (See page 30)

2Load a cassette into the TAPE 2 cassette compartment with the side to be recorded on facing you.

Wind past the leader of the tape, on which recording cannot be performed.

3 Press the button.

Recording will be paused.

4Press the / button to start recording.

To interrupt recording:

Press the button.

To resume recording, press the / button.

To stop recording:

Press the button.

Note:

If you hear a whistling noise while recording an AM station, move the AM loop antenna.

Dubbing from tape to tape

You can record from TAPE 1 to TAPE 2.

1Press the ON/STAND-BY button to turn the power on.

2Load a prerecorded cassette

into the TAPE 1 cassette compartment. Insert a blank tape into the TAPE 2 cassette compartment.

TAPE 1 TAPE 2

It is recommended that the recording tape is the same length as the master tape.

3Press the TAPE (1 2) button until “TAPE 1” appears on the display.

4 Press the button.

Recording will be paused.

5Press the / button to start dubbing.

To stop dubbing:

Press the button.

TAPE 1 and TAPE 2 will simultaneously stop.

Erasing recorded tapes

1Load the tape to be erased into the TAPE 2 cassette compartment with the side to be erased facing toward you.

2Press the TAPE (1 2) button until “TAPE 2” appears on the display.

3Press the button.

4Press the / button to start erasing.

Note:

Make sure that the TAPE 1 is not in use.

CD-G14000

Tape Recording

35