3.SlotintheSoundBartothebasestandaccordingto
yourTVsize.
60"TV{_
_ _J} 70 II TV
___N | Groove to neatly |
_ | the wire in. |
Caution:
•Be very careful to prevent the Sound Bar and Amplifier from falling when mounting on the wall.
•Before mounting, check the wall strength. (Do not put on the veneer plaster or whitewashed wall. The Sound
Bar may fall.) If unsure, consult a qualified service technician.
•Mounting screws are not supplied. Use appropriate ones.
•Check all wall mount angle screws for looseness.
•Select a good location. If not, accidents may occur or the Sound Bar and Amplifier may get damaged.
•SHARP is not responsible for accidents resulting from improper installation.
•Do not let children dangle on the Sound Bar and Amplifier once it is attached on the wall as it can cause damage and injury.
Slot in the wire inside the groove or slit for better wire arrangement.
Suggestion of the
Sound Bars and
LCD TV arrangement.
1. Fix the brackets to the holes as shown.
Model
Model
Model
Caution:
Be careful not to
fix the bracket V
upside down. /%
SHARP designed the Sound Bar and Amplifier so you may hang them on the wall. Use proper screws (not supplied). See below for size and type.
1/8" (3.2 mm)
3/16" _
(5 mm) _ | 3/8" (9 mm) |
7/8" (Min. 22 mm)
m
1 Select the correct screw point marks on the pattern paper according to your TV size. Fix the
pattern paper to the wall in horizontal position as below.
Wall surface
Pattern paper
2 Make a hole on the wall following the screw point marks on the pattern paper by using a drill.
3/8"
Wall surface l
3Fix a wall mount plug (not supplied) into the hole
using a hammer, until it is flush with the wall surface.