Menu operations
Power Control menu
MENU [Power Control]
Audio | Power Control |
No Signal Off | [Disable] |
No Operation Off | [Disable] |
|
|
No Signal Off | TV/AV only |
|
|
Menu Operation: A (page 11)
When set to “Enable” the TV will automatically enter the standby mode if there is no signal input for 15 minutes.
•Five minutes before the TV enters standby mode, the remaining time displays every minute.
NOTE
•When a TV programme finishes, this function may not operate.
No Operation Off | TV/AV only |
|
|
Menu Operation: A (page 11)
When set to “Enable” the TV will automatically enter the standby mode if no operations are performed for 3 hours.
•Five minutes before the TV enters standby mode, the remaining time displays every minute.
Power Management | PC only |
|
|
Menu Operation: A (page 11)
When set, the TV will automatically enter the standby mode.
Item
Off: • No power management
• Factory preset value.
Mode1: • If there is no signal input for 8 minutes, the TV enters the standby mode.
•Even if you start using the PC and the signal inputs again, the TV stays in standby mode.
•The TV turns on again by pressing aon the TV or Bon the remote control unit. (See page 7.)
Mode2: • If there is no signal input for 8 seconds, the TV enters the standby mode.
•When you start using the PC and the signal inputs again, the TV turns on.
•The TV turns on again by pressing aon the TV or Bon the remote control unit. (See page 7.)
Setup menu
MENU [Setup]
Setup | Option |
| Auto Installation |
|
| Programme Setup |
|
| Child Lock |
|
| Position |
|
| WSS | [On] |
| 4:3 Mode | [Panorama] |
| Rotate | [Normal] |
14 | Language | [English] |
|
|
|
Auto Installation | TV only |
|
|
You can run Auto Installation again, even after setting up the preset channels.
1 Press MENU and the MENU screen displays.
2 Press c/dto select “Setup”.
3 Press a/bto select “Auto Installation”, and then press OK.
If you have already set the PIN under “Child Lock”, enter it here.
• See page 16 for setting PIN.
4 Press c/dto select “Yes”, and then press OK.
5 You can set language and country the same as in the initial auto installation. Follow steps 1 and 2 on page 7.
Programme Setup | TV only |
|
|
This section describes how to set up analogue TV channels manually.
1 Press MENU and the MENU screen displays.
2 Press c/dto select “Setup”.
3 Press a/b to select “Programme Setup”, and then press OK.
If you have already set the PIN under “Child Lock”, enter it here.
• See page 16 for setting PIN.
4 Press a/b to select “Auto Search”, “Manual Adjust”, “Sort” or “Erase Programme”, and then press OK.
Auto Search |
|
Manual Adjust |
|
Sort |
|
Erase Programme |
|
No | Yes |
Auto Search
You can automatically search for and download TV channels by performing the procedure below. This is the same function as from programme auto search to preset download in Auto Installation.
1 Repeat steps 1 to 4 in Programme Setup.
2 Press c/dto select “Yes”, and then press OK.
1Programme auto search
2Auto labelling
3Auto sorting
4Preset download
