Sharp LC-32GA8E Still image, Teletext function, Useful features, What is Teletext?, Time display

Press m to display the Teletext.

Useful features

Still image

You can freeze a motion picture on the screen.

1 Press 3.

2 Press 3 again to exit still image.

NOTE

•When this function is not available, “No still image display available.” will display.

•The still image automatically goes out after 30 minutes.

Teletext function

What is Teletext?

Teletext broadcasts pages of information and entertainment to specially equipped television sets. Your TV receives Teletext signals broadcast by a TV network, and decodes them into graphical format for viewing. News, weather and sports information, stock exchange prices and programme previews are among the many services available.

Time display

You can display the time information included in the Teletext broadcasts.

1 Select a TV channel providing Teletext information. (The time information is automatically captured.)

2 Press p. The channel display will appear on the TV.

3 Press p again within the several seconds that the channel display is on the screen.

Time information will display below the channel display for several seconds.

4 Even when you change the TV channel, you can display the time information with steps 2 and 3 above.

NOTE

•The time display cannot be stored once the power is turned off. When you turn on the power, perform steps 1 to 4 again.

•If acquired successfully, the time information will appear in the upper-right corner of the screen by pressing MENU.

Turning on and off Teletext

1 Select a TV channel or external input source providing the Teletext programme.

2

3 Press magain to display the Teletext on the right screen and normal image on the left screen.

•Each time you press m, the screen switches as shown below.

TELETEXT TELETEXT

•If you select a programme with no Teletext signal, “No Teletext available.” displays.

•The same message displays during other modes if no Teletext signal is available.

NOTE

•Teletext will not work if the selected signal type is RGB. (See page 18.)

Button functions

Buttons	Description
P (r/s)	Increase or decrease the page number.
Colour (Red/	Select a group or block of pages displayed
Green/Yellow/	in the coloured brackets at the bottom of the
Blue)	screen by pressing the corresponding
	Colour (Red/Green/Yellow/Blue) on the
	remote control unit.
0–9	Directly select any page from 100 to 899 by
	using 0–9.
f (WIDE	Switch the Teletext image to Full, Upper half
MODE)	or Lower half.
k (Reveal	Reveal or hide hidden information such as
hidden	an answer to a quiz.
Teletext)
3 (Freeze/	Stop updating Teletext pages automatically
Hold)	or release the hold mode.
[ (Subtitle	Display the subtitle or exit the subtitle
for Teletext)	screen.
	• Subtitle will not be displayed when the
	service does not contain the subtitle
	information.
1 (Subpage)	Reveal or hide subpages.
	• Red button: Move to the previous subpage.
	• Green button: Move to the following subpage.
	• These two buttons are shown on the screen
	by the signs land k.

20