Sharp MD-MT877, MD-MT877C manual 22

MD-MT877/MD-MT877C

Servo Pre-Manual Adjustment

M A N U 1		: Pre-Manual Adjustment menu
PLAY
T M P	$ $	: Temperature code indication
		$ $ : Temperature code
SKIP UP	SKIP DOWN	: A signal offset (AINO) measurement
A h
		: Measurement value
SKIP UP	SKIP DOWN	: B signal offset (BINO) measurement
B h
		: Measurement value
SKIP UP	SKIP DOWN	: E signal offset (EINO) measurement
E h
		: Measurement value
SKIP UP	SKIP DOWN	: F signal offset (FINO) measurement
F h
		: Measurement value
SKIP UP	SKIP DOWN
L O N	P	: Laser ON (play power)
SKIP UP	SKIP DOWN	: AB signal level measurement (ABMAXO)
A B
		: Measurement value
SKIP UP	SKIP DOWN	: A-ATT (focus) tentative setting
S a
		: ATT setting
SKIP UP	SKIP DOWN	: B-ATT (focus) tentative setting
S b
		: ATT setting
SKIP UP	SKIP DOWN	: Pit section EF signal level measurement (LPFEFO)
e f
		: Measurement value
SKIP UP	SKIP DOWN	: Pit section adjustment COUT level setting
P C H
		: COUT level setting
SKIP UP	SKIP DOWN	: Groove section EF signal level measurement (LPFEFO)
e f
		: Measurement value
SKIP UP	SKIP DOWN	: Groove section adjustment COUT level setting
G C H
		: COUT level setting
SKIP UP	SKIP DOWN	: TCRS signal level measurement (TCRSMIO)
T C
		: Measurement value
SKIP UP	SKIP DOWN	: E-ATT (tracking) initial setting
S E
		: ATT setting
SKIP UP	SKIP DOWN	: F-ATT (tracking) initial setting
S F
		: ATT setting
SKIP UP	SKIP DOWN	: AB input level measurement (LPFABO)
a b
		: Measurement value
SKIP UP	SKIP DOWN	: A-ATT (focus) initial setting
S A
		: ATT setting
SKIP UP	SKIP DOWN	: B-ATT (focus) initial setting
S B
		: ATT setting
SKIP UP	SKIP DOWN	: TCRS signal offset (TCRSO) measurement
T H
		: Measurement value

*When the [STOP] button is pressed in specific condition, the "TEST MODE STOP" state is set.

*If the [BASS] button is pressed in the laser ON state (with no disc or the lid open), laser power

changes as follows.
	Play back			Record power			Maximum power
			BASS			BASS
	1 (initial value)			10			384
	L O N	P		L O N	R		L O N	M
							BASS

* In the specific setting display state the setting change digit changes when the [P-MODE]

button is pressed.
• In the case of the setup value two digits.
1st digit (initial value) P-MODE	2nd digit
P-MODE
• In the case of the setup value three digits.
1st digit (initial value)	2nd digit	3nd digit
P-MODE		P-MODE
		P-MODE

*In the specific state the setting changes in the range of "0h to Fh" when the [VOLUME +/–] button is pressed.

*If the [DISP] button is pressed, the display changes as follows.

– 22 –