Sharp MD-MT877, MD-MT877C manual 25

MD-MT877/MD-MT877C

Servo Pre-adjustment Value Check

R S L T 1

PLAY

A H

SKIP UP	SKIP DOWN
B H
SKIP UP	SKIP DOWN
E H
SKIP UP	SKIP DOWN
F H
SKIP UP	SKIP DOWN
T H
SKIP UP	SKIP DOWN
e f
SKIP UP	SKIP DOWN
T C
SKIP UP	SKIP DOWN
a b
SKIP UP	SKIP DOWN
P C H
SKIP UP	SKIP DOWN
G C H
SKIP UP	SKIP DOWN
S A
SKIP UP	SKIP DOWN
S B
SKIP UP	SKIP DOWN
S E
SKIP UP	SKIP DOWN

S F

:Pre-adjustment Value Check menu

:A signal offset measurement value (setting)

:B signal offset measurement value (setting)

:E signal offset measurement value (setting)

:F signal offset measurement value (setting)

:TCRS signal offset measurement value

:EF signal measurement value

:TCRS signal measurement value

:AB signal input measurement value

:Pit section adjustment COUT level setting

:Groove section adjustment COUT level setting

:A-ATT (focus) initial setting

:B-ATT (focus) initial setting

:E-ATT (tracking) initial setting

:F-ATT (tracking) initial setting

*When the [STOP] button is pressed in specific menu, the "TEST MODE STOP" state is set.

*In the specific setting display state the setting change digit changes when the [P-MODE]

button is pressed.
• In the case of the setup value two digits.
1st digit (initial value)	2nd digit
P-MODE
P-MODE
• In the case of the setup value three digits.
1st digit (initial value)	2nd digit	3nd digit
P-MODE		P-MODE

P-MODE

*In the specific state the setting changes in the range of "0h to Fh" when the [VOLUME +/–] button is pressed.

– 25 –