MANUAL FINISHING
This function allows you to set for finish on copied or printed pages. You can select the manual finishing mode if the inserter is installed.
When the finisher
Basic operations
1 Place the original | 2 Switch to the manual finishing | 3 Finishing method settings | 4 Start | |
| mode |
|
|
|
| Changing modes from the Home |
|
|
|
| Screen |
|
|
|
|
|
|
|
|
Adjust the inserter tray guide to the pa- per size, and load paper.
(Special media such as transparency film and tab paper cannot be used.)
1Select the appropriate finishing method
2Change the paper tray or output tray as required
Paper Loading and Output Settings
Checking and changing the
output tray
You can check the type and size of paper loaded.
As needed, the paper type and size can be specified for each of the upper and lower trays.
If you wish to change the paper sizes or types, select [System Settings] > [Paper Tray Settings] > [Inserter].
Check the paper type and size
Selects the upper tray as paper tray
Checking and changing the
output tray
The output tray is automatically selected based on the output function you set. If
If you have changed the output tray, the output function may be deselected depending on the original output settings.
Selects the middle tray as the output tray
Selects the offset tray as the output tray
Orientation of placed original
For stapling or punching on the desired position, place the paper as shown in the following:
•For staple function, place the paper face up and align text with the direction of the touch panel display. (For the saddle stitch function, place the paper so that middle surface faces up.
•When using punch or folding function, place the pa- per face up, and align text horizontally and upward with the scan (right) direction.
Selects the lower tray as paper tray
24