Sharp MX-6500N Staple Saddle Stitch Folding function, Setting the number Copies number of pages

Staple

Saddle Stitch Folding function

(When a finisher installed)

This function staples the loaded paper sheets into a sheaf.

1 staple in back

1 staple in front

2 Staples

Setting the number of

copies (number of pages)

This function loads previously sorted sheets and outputs multiple sets at once.

Number of copies setting

Enter the number of output copies (from 1 to 999)

Number of pages setting

(When a saddle finisher (100-sheet stapling) is installed) This function staples each set of copies at two positions in the centre of paper, folds them in half, and outputs them.

(When a trimming module is installed on the saddle finisher) For saddle stitch, it trims a side drop, offering a good-looking output image.

Staples each set of copies at two positions in the centre of paper, and folds them in half during output

Trims a side drop for saddle folding during output

Specify the trimming width within the range of 2.0 to 20.0 mm

Checking and changing

the output tray

The output tray is automatically selected based on the output function you set. If Z-Fold, Half Fold, or Punch is selected, however, you can select the middle or offset tray for the output tray.

If you have changed the output tray, the output function may be deselected depending on the original output settings.

Selects the middle tray as the output tray

Selects the offset tray as the output tray

(When a folding unit is installed)

This function folds paper in Z-fold, C-fold, or other types of shapes.

(When a saddle finisher (100-sheet stapling) is installed)

Paper can be folded in a saddle fold.

*The paper sizes that can be selected vary depending on the type of paper fold.

*Special media such as transparency film and tab paper cannot be used.

Allowable paper sizes:

A3W, A3, B4, A4R, SRA3, 12”x18”, 11”x17”, 8-1/2”x14”, 8-1/2”x11”R, 8K

The fold settings can be configured in [Detail].

Allowable paper sizes:

A3, B4, A4R, 11” x 17”, 8-1/2”x14”, 8-1/2”x11”R This can be used with staple or punch function only when the A3, B4 or 11"x17" paper is used.

Allowable paper sizes:

A4R, 8-1/2”x11”R

Allowable paper sizes:

A4R, 8-1/2”x11”R

Allowable paper sizes:

A4R, 8-1/2”x11”R

Allowable paper sizes:

A4R, 8-1/2”x11”R

Select this to set all pages as one set

*If this setting is enabled, set the [Number of Copies] to "1".

Select this to specify the number of page for each set

Enter a numeric value when [Manual] is selected.

(from 1 to 200 pages)

Punch function

(When a punch module is installed)

This function punches holes in paper. It is available for paper sizes B5R to A3.

You cannot use A3W (12” x 18”) size paper, and special media such as transparency film and tab papers.

Punches holes during output

If the paper size used is A3, B4 or 11”×17”, this function can be used with saddle stitch or folding function for Z-fold.

MANUAL FINISHING 25