Sharp PG-C355W 5Selecting the Dynamic Range, 6Setting the Video System, 7Checking the Input Signal, Signal Adjustment (“SIG-ADJ”Menu)

Signal Adjustment (“SIG-ADJ” Menu)

5Selecting the Dynamic Range

An optimum picture may not be displayed if a DVI-D-capable device’s output signal type and the projector’s input signal type do not match. If this should occur, switch “Dynamic Range”.

Selectable items	Description
Auto	When the black levels of the image show
Standard	banding or appear faded, select the item
Enhanced	that results in the best picture quality. (In
	most circumstances, “Standard” should
	be selected.)

Note

•The Dynamic Range can be selected only when “DVI-D” input mode is selected.

6Setting the Video System

The video input system mode is factory preset to “Auto”; however, a clear picture from the connected audio-visual equipment may not be re- ceived, depending on the Video signal difference. In that case, switch the Video signal.

Selectable items

Auto

PAL

SECAM

*NTSC4.43

NTSC3.58

PAL-M

PAL-N

PAL -60

*When reproducing NTSC signals in PAL video equipment.

Note

•The Video signal can only be set in VIDEO or S-VIDEO mode.

•When “Video System” is set to “Auto”, you may not receive a clear picture due to signal differ- ences. Should this occur, switch to the video system of the source signal.

Menu operation Page 43

7Checking the Input Signal

This function allows you to check the current input signal information.

-48