Adjusting the Projector Function (“PRJ - ADJ” Menu) (Continued)
Menu operation n Page 38
6 Audio Output Type Setting
This function determines whether the audio level output from the AUDIO output (MONITOR output) terminal is fixed or variable by linking with VOLUME.
Selectable | Description | |
items | ||
| ||
|
| |
FAO | Audio output that does not vary in | |
(Fixed Audio | strength with the volume level of the | |
Output) | source projector. | |
|
| |
VAO | Audio output that varies in strength | |
(Variable | with the volume level of the source | |
Audio | projector. | |
Output) |
|
Info
•When “Audio Out” has been set to “VAO”, fi rst make sure to lower the volume of the projector before turning the power on or off and when switching the input.
7 Speaker Setting
Selectable | Description | |
items | ||
| ||
|
| |
On | The audio signal is output from the | |
| internal speaker. | |
|
| |
Off | The audio signal is not output from the | |
| internal speaker. | |
|
|
9 Selecting the Transmission
Speed (RS-232C)
Make sure that both the projector and computer are set for the same baud rate.
Selectable | Description | ||
items | |||
|
| ||
|
|
| |
9600bps | Transmission speed is slow. | ||
38400bps |
|
| |
|
| ||
115200bps | Transmission speed is rapid. | ||
| |||
|
|
| |
0 Fan Mode Setting
This function changes the fan rotation speed.
Selectable | Description | |
items | ||
| ||
|
| |
Normal | Suitable for normal environments. | |
|
| |
High | Set when using the projector at | |
| altitudes of approximately 1,500 meters | |
| (4,900 feet) or more. |
When “Fan Mode” is set to “High”, the fan rotation speeds up, and the fan noise becomes louder.
System Lock Function
This function prevents unauthorized use of the projector. Once this function is activated, users must enter the correct keycode each time the projector is turned on. We suggest you record the keycode in a safe place where only authorized users have access.
8 Audio Input
This function allows you to select an appropriate combination of audio input terminals for each Input mode.
Selectable | Description | |
items | ||
| ||
|
| |
Audio 1 | The AUDIO 1 input terminal is used as | |
| an audio input terminal. | |
|
| |
Audio 2 | The AUDIO 2 input terminal is used as | |
| an audio input terminal. | |
|
|
Info
•If you lose or forget your keycode, contact your nearest Sharp Authorized Projector Dealer or Service Center (see page 61). Even if the product warranty is valid, the keycode reset will incur a charge.
a Setting/Changing the keycode
1
Select “System Lock”, then press
ENTER or Q.
2Select “Next”, then press ENTER.
•The screen for entering the keycode 
appears.
46
