Sharp PG-D45X3D quick start Setting a Password, Select Password, then press Enter or Q

Setting up the Projector Network Environment (“Network” Menu)

Menu operation n Page 38

	Pict.		SCR	PRJ		Network	Help
1	Password					Disable
2	DHCP Client					Off
3	TCP/IP
		MAC Address		XX : XX : XX : XX : XX : XX
4
		Projector		XX-XXXX
		SEL./ADJ.			ENTER		END

1 Setting a Password

If you do not want others to change the setting for the “Network” menu, set a password.

2 Enter the password in “Old Password” using P, R, Q and O, then press ENTER.

a Setting a Password

1 Select “Password”, then press ENTER or Q.

•The screen for entering the password appears.

	Network
Setting the Password
Old Password		– – – –
New Password		–	–	–	–
Reconfirm		– – – –

2 Press P or R to set the first digit

in “New Password”, then press Q.

3 Enter the remaining 3 digits, then press ENTER.

• To return to the previous digit, press O.

4 Enter the same password in “Reconfirm”, then press ENTER.

•The status for “Password” changes to “Enable”.

Note

•Once the password is set, you must enter the password to change the “Network” menu settings.

a Changing the Password

1 Select “Password”, then press ENTER or Q.

•The screen for entering the password appears.

3 Enter the password in “New Password” using P, R, Q and O, then press ENTER.

4 Enter the same password again in “Reconfirm” using P, R, Q and O, then press ENTER.

Note

•If you do not need the password protection for the “Network” menu settings anymore, press ENTER without entering the new password in steps 3 and 4.

•To cancel the password settings, press

RETURN.

If you forget the password

If you forget the password, perform the	Useful Features
following procedure to delete it, then set a
new password.
On the projector, press
.

Note

•If ENTER is held down for more than 5 seconds, the operation buttons on the projector will be locked. (See page 48.)

•You cannot use the buttons on the remote control to delete the password.

49