Sharp PG-D45X3D quick start Resetting the Lamp Timer

4Remove the lamp unit.

•Loosen the securing screws from the lamp unit. Hold the lamp unit and pull it in the direction of the arrow. At this time, keep

the lamp unit horizontal and do not tilt it.

5Insert the new lamp unit.

• Press the lamp unit fi rmly into the lamp unit compartment. Fasten the securing screws.

6Replace the lamp unit cover.

•Align the tab on the lamp unit cover

(1) and place it while pressing the cover

(2) to close it. Then tighten the user service screw (3) to secure the lamp unit cover.

Info

•If the lamp unit and lamp unit cover are not correctly installed, the power will not turn on, even if the power cord is connected to the projector.

Securing screws

2

Resetting the Lamp Timer

Reset the lamp timer after replacing the lamp.

Info

•Make sure to reset the lamp timer only when replacing the lamp. If you reset the lamp timer

and continue to use the same lamp, this may cause the lamp to become damaged or explode.

1 Connect the power cord and open the lens shutter fully.

• Plug the power cord into the AC socket ofAC socket the projector.

2 Reset the lamp timer.

•While simultaneously holding down MENU/HELP, ENTER and R on the projector, press STANDBY/ON on the

projector.

• “LAMP 0000H” is displayed, indicating that the lamp timer is reset.

STANDBY/ON button

MENU/HELP button

ENTER button

R button

Appendix

57