Connecting the Pro- jector to a Computer | Sharp PG-F320W manual

Setting up the Projector Network Environment

1.Connecting the Pro- jector to a Computer

Establishing a one-to-one connection from the projector to a computer. Using a LAN cable (Category 5, cross-over type) you can config- ure the projector via the computer.

1 Disconnect the computer’s LAN cable from the existing network.

A LAN cable being connected to the network

2 Connect a LAN cable (a UTP cable, Category 5, cross-over type) to the projector’s LAN ter- minal and connect the other end of the cable to the computer’s LAN terminal.

LAN cable

(cross-over type, commercially available)

3 Plug the power cord into the AC socket of the projector.

4 Turn on the computer.

ON

Info

Confirm that the LINK LED on the rear of the projector illuminates. If the LINK LED does not illuminate, check the following :

•The LAN cable is properly connected.

•The power switches of both the projector and the computer are on.

This completes the connection. Now proceed to “2. Setting an IP Address for the Computer”.

-10

Image 10

Sharp PG-F320W specifications Connecting the Pro- jector to a Computer

Contents

Setup Manual Connecting Pin Assignments Sub 15 pin female connector Connecting Pin Assignments Computer control Communication conditions RS-232C Specifications and CommandsBasic format Commands ← O K Control Contents BrilliantColorTM OK or ERR PAL Setting up the Projector Network Environment Network settings on the computer Connecting the Pro- jector to a Computer Setting an IP Address for the Computer Confirm or change an IP address for the setup computer Setting up a Network Connection for the Projector DNS Controlling the Projector via LAN Controlling the Projector Using Internet ExplorerVersion 5.0 or later Status Status Confirming the ProjectorControlling the Projector Control Projector Settings & Adjustments Setting and AdjustingSetting the Security Network Security Mail Originator Settings Making General Settings for the Network NetworkSetting for Sending E-mail when an Error Occurs General Mail Recipient Settings Occurs Service & Support Access URL Setting up the Projector Using RS-232C or Telnet When Connecting Using RS-232C When Connecting Using Telnet ClickStartfrom theWindows desk- top and select Run Setup Menu Main Menu Advanced Setup Menu VView All Setting View Setting Detail ListSet Items SSave & Quit Save Settings and QuitQuit without Saving Set Tings QQuit Unchanged Subnet Mask Setting IP Address SettingDefault Gateway Setting User Name Setting Dhcp Client Setting Password SettingProjector Name Setting RS-232C Baud Rate Set Entering Advanced Setup Menu Disconnecting All ConnecSetting Auto Logout Time Data Port Setting Carrying out Network Ping Test Setting of Accept IP Ad- dressAccepting All IP Addresses Return to Default Settings Setting of Search PortReturn to Main Menu Resetting the Lamp Timer of the Projector via LAN Resetting the Lamp Timer of the Projector via LAN Troubleshooting Communication cannot be established with the projector Troubleshooting \ After the initialization, carry out setting again